3.0l wrist pins

cody ward · Jan 17, 2010

dos any one know what needs to be done to remove then replace wrist pins in the pistons i have found nothing and im in the middle of my first full rebuild :headbang:

thanks ahead of time

monsterchuck · Jan 17, 2010

I haven't been that far inside a 3.0 in a while, but if there aren't any circlips holding them in, then they are press-fit. Your going to need a press and the appropriate blocks to press them in/out. I keep my wrist pins in a freezer right up until they go in, makes it a little easier, also helps to heat the connecting rod. You could also take them to a machine shop, I don't imagine that they'd charge very much.

3.0l wrist pins

cody ward

10+ Year Member

monsterchuck

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions