what is this part?


oh sorry and its a 1989 Bronco II
 
Looks like that's the piece for the passenger side back corner of the truck between the wheel arch and taillight
 
thank you, do you mean this part?
what is this part?

i hope that is what you mean because i really need this peice. and how does it go on? just cut out the old and weld in the new?
thanks again
 
wantaranger said:
thank you, do you mean this part?
what is this part?

i hope that is what you mean because i really need this peice. and how does it go on? just cut out the old and weld in the new?
thanks again
Click to expand...
That is the part... except the one you linked to is for the right side (aka: passenger side)

I've seen some people just pop-rivet the replacement panel over top of the rusted out section....

I'd rather do it the right way which involves cutting out where the replacement panel goes and either flanging the existing sheet metal and welding it in or doing a butt-weld to put it in, then smooth out the welds and use some glazing putty to clean it up before painting. It'll look like factory if done right.
 
yea well i need both sides anyways. mines really beat up from trail rash. and i will need some new ones to get her saftey done. then again with the choptop she might not even pass at all. thanks for the help
 
You must log in or register to reply here.

Sponsored Ad

TRS Events & Gatherings

Where We Were in 2025 – The Ranger Station

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_4690.JPEG
IMG_4689.JPEG
IMG_4688.JPEG
IMG_4679.JPEG
IMG_4656.JPEG
IMG_4625.JPEG
IMG_4562.JPEG
IMG_4561.JPEG
IMG_4560.JPEG
IMG_4559.JPEG
IMG_4558.JPEG
IMG_4445.JPEG

Product Suggestions

Back
Top