one piece drive shaft question.
- Thread starter DMB_86
- Start date
adsm08
Senior Master Grease Monkey
⭐Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
- Joined
- Sep 20, 2009
- Messages
- 34,617
- Points
- 3,101
- City
- Dillsburg PA
- Vehicle Year
- 1987
- Engine
- 4.0 V6
- Transmission
- Manual
- Tire Size
- 31X10.50X15
Should. I have an 87 with an M5OD which is the same length as the 146. I put a 1-piece off a 98 in. As long as your truck is a super 4x4, then the 03 shaft will work, you just have to get a second transmission end flange and put it on the back end of the shaft to match your axle companion flange bolt spacing. Also, don't forget to trim your gas tank skid plate at the back. I didn't and haven't had any trouble yet, but I haven't been anywhere but the highway yet. I plan to do it before I get off road.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
