- Joined
- Nov 29, 2008
- Messages
- 488
- Points
- 3,101
- City
- colorado
- Vehicle Year
- 1985,1997
- Transmission
- Manual
Well on labor day my rod bearing on my old 86' yz250 let loose on the first run of the first day. boooooo...... Money has been tight and with all the colorado snow we had, I finally made enough to fund a engine rebuild. I got the crank back from the shop yesterday and expecting the cylinder jug back tomarrow!!! I'm so excited to go terrorize with my bike and the new motor. Its getting all new bearings/seals and the cylinder is getting overbored to 69mm which is a full 1mm over bore with a wiseco pro-lite piston. I'll put some pics up 2maro when I reassemble the 2 case halfs. Sorry for the rant but man am I stoked!!!! 
After this gets done its time to put TBI on the old ranger and replace the floor pans and get some sliders under it.
After this gets done its time to put TBI on the old ranger and replace the floor pans and get some sliders under it.
