Ok, so i just finished dropping in my 302 and got it running. but the choke on my truck avenger carb keeps sticking, and keeps the motor revved up. as soon as it starts up it runs at about 2000 rpm and will stay there as long as the motor is running. what do i have to adjust to fix this? i'm new to carbs so could be missing something obvious.
carb question
- Thread starter cp
- Start date
- Joined
- Apr 26, 2009
- Messages
- 7,738
- Points
- 3,101
- City
- Lafayette, IN
- Vehicle Year
- 1983
- Transmission
- Manual
Make it a manual choke if you can. One thing that will help peolpe is what kind of carb., the specs on it and the brand.
RangerFabWorks
The O.G blackwidow67
TRS Forum Moderator
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
V8 Engine Swap
- Joined
- Jan 31, 2009
- Messages
- 5,298
- Points
- 3,101
- Age
- 34
- City
- Lexington
- State - Country
- NC - USA
- Vehicle Year
- 1990
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Engine
- 5.0
- Transmission
- Manual
- Tire Size
- 235/70 275/60
loosen the screws on the choke assemble. the round black thing on the side of the car. and rotate it counter clockwise untill you see the choke start to open. then tighten the screws back up.
make sure to do this when the choke is on, meaning with the engine cold, pump the gas to kick in the choke, then set it.
make sure to do this when the choke is on, meaning with the engine cold, pump the gas to kick in the choke, then set it.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
