Seat belt needs replaced

[ratchet]

The latch on my seat belt quit working & needs replaced. The bolt holding it to the floor looks to be a torx head bolt. Does anyone know what size I need to buy to remove it?:icon_confused:

[Black'03LevelII]

if I remember right it is either a T30 or T40 bit I can double check at work tomorrow (where the tools are) and re post with for sure info.

ok just got to work a little while ago and double checked. in my '03 it is a T50 torx bit, hope this helps you out!

[predator]

most stores (such as sears) will allow an employee to walk out into the parking lot with you so you can double check the size, i just explain the situation and the guy is usually more than happy to help out.

[Murdock]

I cheated with mine. I used vice grips to losen it and an allen wrench to turn it out.

[Ranger44]

T-50

Your lucky yours were easy to get out. I broke off 2 t-50's and then had use torch before mine came out.

[ratchet]

Thanks for the help everyone. It sounds like I'm in for a real knuckle busting time when I go to get those bolts out.:damnit1:

[85_Ranger4x4]

I fought mine tooth and nail, they come out the bottom of the cab are exposed to whatever your tires can throw on them. Not one of Ford's better moves...:rolleyes:

It might help to clean them with a wire brush and a nut from underneith before you try to take them out.