well my 89 ext cab 2.9 a4ld ranger has a pretty bad vibration during acceleration. it seems to be coming from the rear. but the u joints and pinion all seem fine.
any suggestions?
any suggestions?
vibration
- Thread starter zukirider21
- Start date
may be a flat spot in tire thats what wrong with mine.
hmmm... and the truck has been sitting a long time, too.
well maybe if i get lucky it will go away when i put on my 32" swampers in the next week or 2...
thanks man
well maybe if i get lucky it will go away when i put on my 32" swampers in the next week or 2...
thanks man
kunar
Forum Staff Member
TRS Forum Moderator
⭐Supporting Member
Article Contributor
TRS Event Participant
V8 Engine Swap
- Joined
- Jun 10, 2003
- Messages
- 4,177
- Points
- 5,101
- City
- Toledo
- State - Country
- OH - USA
- Vehicle Year
- 1987
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Engine
- 351
- Transmission
- Manual
if its lifted, it might be the 2 piece drive shaft, they dont like lifts. it could still be a bad u-joint as well. i had one that was junk but it still felt tight. the needle bearings inside had all broken/crushed and the u-joint was off center
if it is the tire let me know.
Sponsored Ad
TRS Events & Gatherings
Latest posts
-
-
-
-
-
-
Duraflex Hood - anyone have one?- Latest: PetroleumJunkie412
-
-
-
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
