- Joined
- Nov 4, 2008
- Messages
- 361
- Points
- 3,101
- Vehicle Year
- 2006
- Transmission
- Manual
I installed the new oil seal today and think I did a good job. But not sure if it's all the way in. I hammered it in very carefully using a matching socket untill it was flush with the axle and didn't seem like it would go any farther even with some harder hits so I left it like that but according to my measurements that means there might still be a small space between the seal and bearing, and not sure if I heard that its supposed to be pressed all the way till it hits the bearing in which case it would go deeper than just being flush with the axle.
