- Joined
- Aug 9, 2007
- Messages
- 167
- Points
- 3,101
- City
- Northeast, TN!!
- Vehicle Year
- 1988
- Transmission
- Manual
I took my factory water temp gauge out because the temp gauge in the dash is bad and doesn't work so I installed a sunpro one.
Started the bronco it wont idle starts runs an dies..
Well after a few minutes of tinkering I discover that the factory water temp gauge must be plugged in for it to idle...???
Which leads me to my question.
Can I just leave it plugged up and e-tape an zip tie it back out of the way? Or can I cut the plug off of it an put a butt connector on it?
Just curious what someone else has done or if you've encountered this problem b4 thanks!
Tiny
Started the bronco it wont idle starts runs an dies..
Well after a few minutes of tinkering I discover that the factory water temp gauge must be plugged in for it to idle...???
Which leads me to my question.
Can I just leave it plugged up and e-tape an zip tie it back out of the way? Or can I cut the plug off of it an put a butt connector on it?
Just curious what someone else has done or if you've encountered this problem b4 thanks!
Tiny
