uneven ride height


arren

arren

15+ Year Member

Joined
Jun 27, 2009
Messages
108
Points
3,101
Age
33
City
vancouver, wa
Vehicle Year
1994
Transmission
Manual
on my 83 4cyl 4x4 ranger i had to take out the whole drivers side axle beam to do some work on the diff. to put it back in i had to loosen where the radius arm bolts to the beam in order to get both the radius arm and the axle pivot bracket to line up so i could properly bolt it all back in. well after getting it all back together i noticed now that my drivers side sits 3/4" lower than the passenger side. if i didnt make that too confusing could what i did be the cause of the uneven height? if so how might i go about fixing this?
thanks, arren
 
make sure all is tight and drive it around the block and check height again. Sometimes when you jack a truck up and let it down the spring and shock will keep one side higher than the other. Let the suspension cycle a couple of times and should level out. If not then it has the ranger lean.
 
Check that the coil is seated correctly in it's mounts.
Also check that there isn't any issues with the rear leaf spring on that side (cracked/broken leaves, rusted/broken mounts, etc.).

If all checks out then like said, it's probably the typical lean many of these trucks have.
A washer or two as shims under the driverside lower coil seat will level it out.
 
thanks guys. if this is a common thing then im not gonna worry too much about it. i probably never noticed it before anyway then thought to look and noticed it. im going to get an alignment soon so all should be fine right?

also, off subject but i dont want to post another thread: does anyone know what size the fuel tanks in my duel tank 83 are?
 
Sasquatch_Ryda said:
Rangers tend to develop a lean to the drivers side, this is due to the gas tank being on that side.
Click to expand...

Wow, so simple I never thought of it. Thanks.
 
arren said:
thanks guys. if this is a common thing then im not gonna worry too much about it. i probably never noticed it before anyway then thought to look and noticed it. im going to get an alignment soon so all should be fine right?
Click to expand...

Alignment won't get rid of the lean, but the lean itself doesn't harm anything. Like I mentioned, a washer or two under the driverside coil will level it.

See these pages, and then think of one or two thin washers on one side under the stock coil seat.

http://www.therangerstation.com/tech_library/factoryspacer.htm
http://www.therangerstation.com/tech_library/WasherCoilSpacers.htm
 
You must log in or register to reply here.

Sponsored Ad

TRS Events & Gatherings

Where We Were in 2025 – The Ranger Station

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_4690.JPEG
IMG_4689.JPEG
IMG_4688.JPEG
IMG_4679.JPEG
IMG_4656.JPEG
IMG_4625.JPEG
IMG_4562.JPEG
IMG_4561.JPEG
IMG_4560.JPEG
IMG_4559.JPEG
IMG_4558.JPEG
IMG_4445.JPEG

Product Suggestions

Back
Top