- Joined
- Aug 7, 2009
- Messages
- 5
- Points
- 3,001
- Vehicle Year
- 1995
- Transmission
- Manual
I took out my cluster and drove to my workshop. I had my scanner hooked up to the odb2 while I drove so I could still know how fast I was going.. I noticed that while I was driving, the voltage on the batt was reading at 11.9.
When I got where I was going, cluster got plugged back in and volts went back to 13.6. Is there something I need to short to keep the volts where they should be?
I am wanting to make a custom cluster, and just want to make sure I am not missing something..
When I got where I was going, cluster got plugged back in and volts went back to 13.6. Is there something I need to short to keep the volts where they should be?
I am wanting to make a custom cluster, and just want to make sure I am not missing something..
