Caster

PlumCrazy · Aug 23, 2009

I am making some extended radius arms to go with my 4 inch lift. My question is, Where do I measure the caster from? Am I basically setting the pinion angle? Should the axle beam lean forward or be 100% vertical? I know the rear pinion is set at 6 or 6.5 degrees, but the front shaft is shorter, so should the pinion angle be a little more aggresive?

-plumcrazy

4x4junkie · Aug 24, 2009

The axle beam should be dead-vertical (or horizontal if you're measuring it right where the radius arm attaches). This should put you right around 5° caster at the wheel when using a 0° offset bushing.

PickupMan04 FX4 L2 · Aug 24, 2009

Damn, i thought you were talking about caster oil..

4x4junkie · Aug 24, 2009

PickupMan04 FX4 L2 said:
Damn, i thought you were talking about caster oil..

I believe that would be Castor oil

PlumCrazy · Aug 24, 2009

The truck has 2 degree bushings. So I want the beam to 100% vertical, if the beam leans foward a little will it mess with anythng other than curving the coil spring a little?

crawlin91 · Aug 24, 2009

info in this thread
http://www.therangerstation.com/forums/showthread.php?t=34439

4x4junkie · Aug 25, 2009

PlumCrazy said:
The truck has 2 degree bushings. So I want the beam to 100% vertical, if the beam leans foward a little will it mess with anythng other than curving the coil spring a little?

It could cause the caster to be incorrect (or cause it to be maxed out one way or the other). If you're setting this up from scratch, I would do it so you have 4-5° caster using a 0° bushing (or with the bushing zeroed out for caster).

AllanD · Aug 25, 2009

Not enough caster will lead to a truck that "Wanders"

Uneven caster (side to side) is the most common cause of a truck that "pulls"

I purposely put an STX drop radius arm bracket set on my truck to INCREASE the caster as much as possible.

If your truck spends a lot of time at highway speeds on the interstate
the more caster you can get the better.

Caster helps the vehicle to track straight.

Caster also increases "road feel" and the tendency for the steering
to return to center when you are comming out of a turn.

On my truck when cornering hard with a bit of oversteer I can "unload" the suspension by momentarily releasing the steering wheel and letting the steering return (pretty agressively) to "Center"

I NEVER have to wonder where "center" actually is, because it takes some force to have it anywhere other than center.

Makes it real easy to keep it going straight on those long lonely roads.

Oddly it makes it more fun in the twisties too, because you turn into the turn but it "un turns" itself.

AD

Caster

PlumCrazy

<<--Live Rangerously-->>

4x4junkie

Forum Staff Member

PickupMan04 FX4 L2

Guest

4x4junkie

Forum Staff Member

PlumCrazy

<<--Live Rangerously-->>

crawlin91

15+ Year Member

4x4junkie

Forum Staff Member

AllanD

TRS Technical Staff

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions