Welcome Visitor! Please take a few seconds and 
- Joined
- Jan 2, 2001
- Messages
- 8,012
- Reaction score
- 15
- Points
- 38
- Age
- 40
- Location
- Lancaster, Ohio
- Vehicle Year
- 2016
- Make / Model
- Chevy 3500HD
- Engine Type
- V8
- Engine Size
- 6.6L
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Total Lift
- 5"
- Tire Size
- 35"
Hey all,
My B2 has a noise that I thought was associated with the U-joint rear driveshaft. I took that shaft out and put in the old CV joint shaft and the noise is still there..
It is ONLY when applying the brakes. It's a clunk, clunk, clunk that is dependant on the wheel speed. I have pulled the brakes apart and I can't see anything wrong. I thought it was the d/s because right after I replaced the u-joints it went away for a while..
No it is back. Any ideas?
My B2 has a noise that I thought was associated with the U-joint rear driveshaft. I took that shaft out and put in the old CV joint shaft and the noise is still there..
It is ONLY when applying the brakes. It's a clunk, clunk, clunk that is dependant on the wheel speed. I have pulled the brakes apart and I can't see anything wrong. I thought it was the d/s because right after I replaced the u-joints it went away for a while..
No it is back. Any ideas?
