Transmission wont go into gear

dony852 · Aug 3, 2009

I have a 93 ford ranger 4.0 with an automatic transmission. I just replaced the motor with another 4.0. The motor runs strong but now the tranny wont go into any gears. I can hear the rpms change as I go through the gears but somethings not catching. I've ran it for a while to see if the torque converter needed filled but there is still nothing. It worked before I replaced the motor. Any ideas?

budro · Aug 3, 2009

Make sure your fluid is all the way full. A4LD's are notorious about not moving once the fluid goes down a bit. Or they take like 30 seconds sometimes just to engage when you put it in drive.

dony852 · Aug 3, 2009

I've done that, I've even over filled it to see if the torque converter was to low and still nothing.

Transmission wont go into gear

dony852

10+ Year Member

budro

15+ Year Member

dony852

10+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions