Transmission wont go into gear after changing slave cylinder

exo600 · Jul 12, 2009

I dropped the transmission today to replace the slave cylinder. I got it all back together and it is impossible to shift into any gear. the only thing i think i did wrong was once i bolted up the tranny, before I put the shifter and the drive shaft back on I turned on the motor to see if the clutch was disengageing with the new slave cyl. It made a mess with the tranny fluid, but the new slave was working fine so I proceded to assemble my truck. Could I have messed some thing up, or did i not alinge something correctly?

Its a 2003 Mazda B2300, 5spd Manual. 129000 miles

Any help is appreciated.
Robert

Rifleman · Jul 12, 2009

Something moved somewhere. I'd say drop it and inspect.

mjonesjr · Jul 12, 2009

Did you bleed the slave cylinder?

exo600 · Jul 12, 2009

mjonesjr said:
Did you bleed the slave cylinder?

the slave cylinder was bleed

exo600 · Jul 12, 2009

i read somewhere that the trans can be put in netral manually by removing a cover and moving the synchros with a scerwdriver. I was wondering if anybody how to do that?

mjonesjr · Jul 12, 2009

You may have to bleed the crap out of it. When I did the swap on my BII, it took a lot of bleeding.

rangerstzz · Jul 12, 2009

exo600 said:
I dropped the transmission today to replace the slave cylinder. I got it all back together and it is impossible to shift into any gear. the only thing i think i did wrong was once i bolted up the tranny, before I put the shifter and the drive shaft back on I turned on the motor to see if the clutch was disengageing with the new slave cyl. It made a mess with the tranny fluid, but the new slave was working fine so I proceded to assemble my truck. Could I have messed some thing up, or did i not alinge something correctly?

Its a 2003 Mazda B2300, 5spd Manual. 129000 miles

Any help is appreciated.
Robert

will it shift with the engine off? if not, then the shifter is installed incorrectly.

exo600 · Jul 12, 2009

fixed, the had to move somethings around under the shifter so it would fall back into place correctly.

Transmission wont go into gear after changing slave cylinder

exo600

10+ Year Member

Rifleman

15+ Year Member

mjonesjr

I dance with the Devil...

exo600

10+ Year Member

exo600

10+ Year Member

mjonesjr

I dance with the Devil...

rangerstzz

15+ Year Member

exo600

10+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions