D35 locker (jeep or ranger)


nooberiffic

15+ Year Member

Joined
May 21, 2009
Messages
173
Points
3,101
Vehicle Year
1990
Transmission
Manual
I want to put a lock right in my D35 front. So far I can only find a lock right listed for the D35 (Jeep). I know that the D35 is a rear axle for a jeep and a front axle for a ford. Will a locker for a D35 rear fit in the D35 front?

Also, is the axle shaft from a '93 Explorer 8.8 3/4 inch or 7/8th?
 
Last edited:
no i dont think so because i asked a question like that once about dana 30 cherkoee front axle, because i have a set of 4:56 gear for it and asked if they would fit in a dana 35 ford and everyone was going nuts, telling me stuff that i knew that saying i was wrong. so they wouldnt answer your questions about jeeps. they hate they i guess???
 
The lockright should fit easily.
The jeep gears won't work because the ford D35 uses reverse cut gears.
Otherwise, a D35 is a D35.

Ken.
 
Thanks man. I was wondering why I couldnt find a D35 lockright marked ford.
 
Actually, many Jeep carriers are different internally. A Jeep Lock-Right locker may not fit the Ford carrier. The carriers are the same externally however, so you could swap a Jeep D35 carrier into your Ford axle and then you'd be able to use the Jeep Lock-Right.
 
Aussie Locker lists the correct locker for the D35 TTB and it's cheaper than the lock-right...
Also, is the axle shaft from a '93 Explorer 8.8 3/4 inch or 7/8th?
It's not the axle shaft, it's the cross pin. All 31 spline 8.8s built after 86 or so have 7/8th cross pins. 28 spline 8.8s and pre-86ish 31 spline 8.8s have 3/4" cross pins.
 
Last edited:
:icon_thumby:thanks, you learn something new every day.
 

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram


Product Suggestions

Back
Top