- Joined
- Oct 21, 2008
- Messages
- 24
- Points
- 3,101
- Vehicle Year
- 1988
- Transmission
- Manual
I dont know if this is the right place for this post but here it goes.
So i just finished replacing the head gasket on my 87 2.3l. I just finished putting it all beack together and re-connecting all the wiring and the truck will start but will not stay running. All power is lost once the ignition is allowed to go to the run position. I can hold the key in crank position just enough to keep power but not allow the starter to engage. Any ideas what i should be looking at as the problem. Any imput is appreciated
So i just finished replacing the head gasket on my 87 2.3l. I just finished putting it all beack together and re-connecting all the wiring and the truck will start but will not stay running. All power is lost once the ignition is allowed to go to the run position. I can hold the key in crank position just enough to keep power but not allow the starter to engage. Any ideas what i should be looking at as the problem. Any imput is appreciated
