need help asap


bump i realy need help, i only have a couple of days and the parts truck has to go and if its not pretty much straight forward, then im not going to bother.
 
Bump, i finally started and ran into a couple of problems, first off , i thaught there was a plug in the firewall for the clutch master cylinder? is it the same one that my trans shift line runs through? if so im geussing i need to drill the 2 holes for it to bolt up, also what year end peice(attached to drive shaft and slides over the spline in the trans/drive shaft can i use, the truck is a 98 shortbox single cab, and the donoir truck is a 94 long box. i think thats all the problems so far, i would apreciate any help, im trying to get this summed up by tomorow night as mondays are my days off.
 
You must log in or register to reply here.

Sponsored Ad

TRS Events & Gatherings

Where We Were in 2025 – The Ranger Station

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_4690.JPEG
IMG_4689.JPEG
IMG_4688.JPEG
IMG_4679.JPEG
IMG_4656.JPEG
IMG_4625.JPEG
IMG_4562.JPEG
IMG_4561.JPEG
IMG_4560.JPEG
IMG_4559.JPEG
IMG_4558.JPEG
IMG_4445.JPEG

Product Suggestions

Back
Top