- Joined
- Jun 2, 2009
- Messages
- 5
- Points
- 3,001
- Transmission
- Automatic
Hello everyone, I noticed my 1993 ranger xlt 4x4 sits higher (looks pretty close to a 2" lift) then other stock rangers of the 93-97 range. It still has its stock suspension, in the rear it has the factory blocks under the springs. In the front I believe the springs are slightly larger then none XLT models of the 93-97 range. My question is since this is factory if I was to order a 4" suspension lift my total lift would only be about 2", correct?
If it is just a 2" total lift compared to my factory hight would I be ok just ordering new springs, shocks, sway bar drop brackets, longer brake lines and pitman arm without radius arm drop brackets and axle pivot drop brackets?
If it is just a 2" total lift compared to my factory hight would I be ok just ordering new springs, shocks, sway bar drop brackets, longer brake lines and pitman arm without radius arm drop brackets and axle pivot drop brackets?
Last edited:
