I hope I'm not asking a question that has already been asked but can you swap a gen2 B2 interior into a gen1 B2? Specifically an 88.
Thanks. rs
Thanks. rs
B2 Interior Swap
- Thread starter Sultan
- Start date
- Joined
- Apr 11, 2008
- Messages
- 200
- Points
- 3,101
- Age
- 37
- Vehicle Year
- 1994
- Transmission
- Manual
I believe you can. I havent done it so im not 100% sure
- Joined
- Oct 2, 2007
- Messages
- 195
- Points
- 3,101
- City
- North East GA
- Vehicle Year
- 1985
- Transmission
- Manual
It is possible, a few of the screw holes or bolt holes won't line up 100% but it is relatively easy. I swapped in an ENTIRE interior from a 90' BII into my 85' BII. I think the only real problem was the driver side seat. I had to drill one bolt hole in the floorboard. Me and dad did it in our garage...so you will be fine. 
EDIT: Head liner was a pain, Had to move the top support bar running across the middle of the back of the truck. ( between the rear windows ) The 85' was more forward than the 90'. We had to take it out and move it back a few inches. Pain b/c we had to drill out the rivets holding it in place and rivet it back in place, be careful not to crack the windows. Had to do a few measurements to make sure we had it centered. Take a look and you'll see what I mean.
EDIT: Head liner was a pain, Had to move the top support bar running across the middle of the back of the truck. ( between the rear windows ) The 85' was more forward than the 90'. We had to take it out and move it back a few inches. Pain b/c we had to drill out the rivets holding it in place and rivet it back in place, be careful not to crack the windows. Had to do a few measurements to make sure we had it centered. Take a look and you'll see what I mean.
Last edited:
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
