2.3 Tune_up

91 ranger guy · May 16, 2009

hey guys im tuneing up my truck and was woundering if there was a more detailed view of the plug wire routing on my truck. the haynes manual is not real clear. this is my 1st 4 cylinder. :icon_confused:

mrcarcrazy · May 18, 2009

what exactly is the question? would a picture help?

Basically keep the wires off things like exhaust manifold. and if the all reach their respective "point A's, and point B's" then you're golden.

I did this yesterday...and now have a inch long gash on my Left ring finger...thank god for superglue.

I ran the 4 on the intake side across the valve cover between the Vent tube and the throttle body. I assume those are the ones confusing you.

91 ranger guy · May 19, 2009

yea pics would be good, i thought one coil pack ran one side and the other coil pack ran the other side.

fastpakr · May 19, 2009

Are there no plug wires there now? If so, all you need to do is replace them one a time or draw the layout before you start.

mrcarcrazy · May 19, 2009

PM me your email address. I'm @ work and I can drop downstairs take a pic and email it to you.

Yes one coil pack provides spark to one side, and the other to the other side....
but yeah PM me an email address and I'll take a pic and email it to you.

91 ranger guy · May 19, 2009

my email is fordman2812004@yahoo.com thanks man.

mrcarcrazy · May 19, 2009

pic sent. lemme know if that gets the job done. if u need more detail I can do that too...that was just a quick iphone pic.

91 ranger guy · May 20, 2009

hey man good pic, can i get some more detail, why on mine do i have one coil pack on the drivers side and one on the passenger side? is mine normal? would mine wire up like urs?

91 ranger guy · May 23, 2009

any body have any pics or anything of plug wire placement on a 2.3 with coil packs on each side of the motor?

fastpakr · May 23, 2009

I'll go back to my initial question - are there no plug wires there at all now? If so, that will give you the correct routing.

Z3CHYD · May 23, 2009

91 ranger guy said:
hey man good pic, can i get some more detail, why on mine do i have one coil pack on the drivers side and one on the passenger side? is mine normal? would mine wire up like urs?

Yours is one of the earlier "dual-plug" setups, then later on, about 94-95 or so they put both coil packs on the drivers side. On my 97 there both on the drivers side

RobbieD · May 23, 2009

The coil packs on my '94 are on the passenger side of the motor.

91 ranger guy · May 23, 2009

i took them off and forgot where they go... i know ur suposed to do one at a time but i got side tracked and ending up taking them all off cause i cleaned and painted the motor.

mrcarcrazy · May 24, 2009

RobbieD said:
The coil packs on my '94 are on the passenger side of the motor.

same on my 95.

There's got to be a early dual plug owner on here that can take a pic or two for a fellow ranger-fanatic....

scotts90ranger · May 24, 2009

the coil packs should be labeled 1-4, 1 is the front cylinder, from there 2 3 4, just route them so they don't touch stuff and get them in the right order

2.3 Tune_up

New Member

New Member

New Member

Forum Staff Member

New Member

New Member

New Member

New Member

New Member

Forum Staff Member

Active Member

2.9l Mafia

New Member

New Member

Well-Known Member

Sponsored Ad

Sponsored Ad

Member & Vendor Upgrades

Truck of The Month

Recently Featured

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store

Sponsored Ad

Sponsored Ad

Sponsored Ad

Amazon Deals