Hahnsb2
04-26-2009, 12:54 AM
I will first say that it is on my Dakota but It's still an exhaust review.
I purchased this muffler through Horsepowerfreaks for $135. It is full stainless with a polished exterior. 3030 designates a 3" inlet and 3" outlet. The Aero turbine is unlike any other muffler, it is straight through yet it uses no packing and incorporates a aerofoil cone and louvers into the design.
http://images.channeladvisor.com/Sell/SSProfiles/22001003/Images/3/air_flow_illus.jpg
I installed it by welding it in place of the 40 series Flowmaster I was running before.
When I first started it it sounded very similar to the 40 series, yet after 2500-3000 RPMs it's a whole new beast. It is much louder when you stomp on it and a much more aggressive sound yet when I'm cruising down the freeway I can hardly hear it unlike the Flowmaster, it's quite enjoyable. There was also a noticeable small performance increase around 4000 RPMs.
A friend also recently installed an AT 2525 on his Toyota with a 22re and I must say it sounds damn good for a 4 banger.
Another friend of mine (forum member "Grunizzle") is probably getting one for his 4.0 ranger soon so I'll be sure to post up sound clips.
My only complaint is the price, I wish they're sell an unpolished version to bring down the cost a little.
I give it a 9.5 out of 10
Here's a picture of it installed and a couple videos.
http://i391.photobucket.com/albums/oo356/HahnsB2/HPIM0704.jpg
http://www.youtube.com/watch?v=Q2rvrPgAk50&feature=channel_page
http://www.youtube.com/watch?v=hvsgo2HEG00&feature=channel
I purchased this muffler through Horsepowerfreaks for $135. It is full stainless with a polished exterior. 3030 designates a 3" inlet and 3" outlet. The Aero turbine is unlike any other muffler, it is straight through yet it uses no packing and incorporates a aerofoil cone and louvers into the design.
http://images.channeladvisor.com/Sell/SSProfiles/22001003/Images/3/air_flow_illus.jpg
I installed it by welding it in place of the 40 series Flowmaster I was running before.
When I first started it it sounded very similar to the 40 series, yet after 2500-3000 RPMs it's a whole new beast. It is much louder when you stomp on it and a much more aggressive sound yet when I'm cruising down the freeway I can hardly hear it unlike the Flowmaster, it's quite enjoyable. There was also a noticeable small performance increase around 4000 RPMs.
A friend also recently installed an AT 2525 on his Toyota with a 22re and I must say it sounds damn good for a 4 banger.
Another friend of mine (forum member "Grunizzle") is probably getting one for his 4.0 ranger soon so I'll be sure to post up sound clips.
My only complaint is the price, I wish they're sell an unpolished version to bring down the cost a little.
I give it a 9.5 out of 10
Here's a picture of it installed and a couple videos.
http://i391.photobucket.com/albums/oo356/HahnsB2/HPIM0704.jpg
http://www.youtube.com/watch?v=Q2rvrPgAk50&feature=channel_page
http://www.youtube.com/watch?v=hvsgo2HEG00&feature=channel