- Joined
- Apr 18, 2009
- Messages
- 9
- Points
- 3,001
- Vehicle Year
- 1991
- Transmission
- Manual
I just replaced my starter solenoid on my 91 ranger 4.0. I screwd up and forgot to mark my wires before removing them so I am needing help putting them back on. My main concern is for the power distribution box wire that goes to the relay. Here is the way I have it and tell me if I am wrong.
On the left side of the solenoid if looking at it straight on.
1. The left side of the wire that connects to the left and right side of the solenoid.
2. Ground
3. Yellow wire with fuse
4. The wire from the Power Distribution Box *this is the one i am not sure wbout i am almost positive that 1-3 is right.
On the left side of the solenoid if looking at it straight on.
1. The right side of the wire that connects to left and right side of the solenoid.
On the left side of the solenoid if looking at it straight on.
1. The left side of the wire that connects to the left and right side of the solenoid.
2. Ground
3. Yellow wire with fuse
4. The wire from the Power Distribution Box *this is the one i am not sure wbout i am almost positive that 1-3 is right.
On the left side of the solenoid if looking at it straight on.
1. The right side of the wire that connects to left and right side of the solenoid.
