I just droped in a 2.5 1999 after block and head rebuild. The engine fired up fine, it ran a little rough at low RPM for about 10min and then there was a ping under the valve cover and it died. Pulled the intake off and the valve cover, we found a broken rocker arm on #1 piston. Its sunday and no parts stores where open at 5pm. Two questions, should I go back to the shop that did the rebuild and ask them to replace the rocker arm or just order a new one? Second I have been looking around online and I can't seem to find any providers for this part. Any suggestions would be much appriciated.
Problems with New Rebuild - Rocker Arm
- Thread starter RangerDAD
- Start date
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
