- Joined
- Oct 14, 2007
- Messages
- 2
- Points
- 3,001
- Vehicle Year
- 94
- Transmission
- Automatic
So I am trying to reinstall my new torque converter and trans and here is my question.
It's my understanding that I should seat the converter on the trans and then bolt the converter nuts to the flywheel through the starter hole. How can I crank the engine to get the four studs where I need them to be without pulling the radiator and draining the coolant , etc? I just really don't want to do that unless I have to.
It's my understanding that I should seat the converter on the trans and then bolt the converter nuts to the flywheel through the starter hole. How can I crank the engine to get the four studs where I need them to be without pulling the radiator and draining the coolant , etc? I just really don't want to do that unless I have to.
