Welcome Visitor! Please take a few seconds and 
du510
New Member
- Joined
- Aug 21, 2007
- Messages
- 332
- Reaction score
- 0
- Points
- 0
- Location
- Stuck between NYC & Boston
- Vehicle Year
- 1994
- Make / Model
- MAZDA
- Transmission
- Manual
So about a month back, I lifted the front another 2" with coil spacers underneath my RC 4" coils. I had an alignment done etc etc.
Soon after, I did some serious 4wheeling with great success, no issues.
About a week later I notice an occasional clunking noise in the front end. I can hear it from the inside, and today I was able to hear it from the outside. It sounds like a piece of sheet metal bending, a bit of a clunk noise with a tone. It makes this noise when the suspension is compressed...
The radius arm bushings are tight, the springs are tight, the shocks are tight. Any ideas guys?
Soon after, I did some serious 4wheeling with great success, no issues.
About a week later I notice an occasional clunking noise in the front end. I can hear it from the inside, and today I was able to hear it from the outside. It sounds like a piece of sheet metal bending, a bit of a clunk noise with a tone. It makes this noise when the suspension is compressed...
The radius arm bushings are tight, the springs are tight, the shocks are tight. Any ideas guys?
