• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

hot but no heat


poda

New Member
Joined
Dec 13, 2008
Messages
17
Reaction score
1
Points
0
Location
centeral wisconsin
Vehicle Year
1992
Make / Model
ford
Engine Size
4.0
Transmission
Manual
I have a 92 4.0 ranger, and when it's really cold outside around -5 or colder my heater dosen't work. But at the same time the engine is runing very hot, could this be the thermostat?
 


Wicked_Sludge

New Member
Joined
Aug 6, 2007
Messages
6,937
Reaction score
43
Points
0
Age
38
Location
Westport, WA
Vehicle Year
1993
Make / Model
Ford
Engine Size
3-point-GO
Transmission
Manual
the factory gauge is flunky, id varify the engine is reaching operating temp with an aftermarket gauge or IR thermometer. if it is, probably a plugged heater core. if it isnt, replace the t-stat.
 

poda

New Member
Joined
Dec 13, 2008
Messages
17
Reaction score
1
Points
0
Location
centeral wisconsin
Vehicle Year
1992
Make / Model
ford
Engine Size
4.0
Transmission
Manual
the factory gauge is flunky, id varify the engine is reaching operating temp with an aftermarket gauge or IR thermometer. if it is, probably a plugged heater core. if it isnt, replace the t-stat.
Yeah it was hot, there was steam coming out from under the hood. I also noticed under the hood that there was coolant everyware around the resivour tank, would this happen because it got really hot? I'm thinking it may be the t stat also, how would I check the heater core to see if it's plugged? thanks!
 

BlackBII

Ranger Custom
Article Contributor
OTOTM Winner
TRS Banner 2010-2011
Truck of Month
Joined
Aug 14, 2007
Messages
7,896
Reaction score
982
Points
113
Location
UT
Vehicle Year
1989
Make / Model
Ford
Engine Type
4.0 V6
Transmission
Manual
2WD / 4WD
4WD
Total Lift
5
Tire Size
33
You can pull the heater core and run a hose through it, see if it is clogged.

If the fluid is coming out of the resovoir, I would suspect maybe a stuck thermostat, as the fluid may not be circulating, over heating the truck.
 

cocoasranger

Member
Joined
Aug 10, 2007
Messages
584
Reaction score
5
Points
18
Location
south central Pa.
Vehicle Year
1989
Make / Model
Ford
Transmission
Manual
Check the radiator cap. If it is weak and/or has a bad seal it can both leak coolant like you describe and also not allow pressure to build up in the system which reduces heat transfer and efficiency. It's cheap insurance to put on a new cap if you are not sure how good the present one is, plus it only takes a few seconds to install.
 

Doofy

Member
Supporting Member
U.S. Military - Veteran
Joined
Jul 27, 2008
Messages
947
Reaction score
7
Points
18
Location
Alaska
Vehicle Year
1998
Make / Model
Ford
Engine Size
3.0
Transmission
Manual
My credo
Shit Happens...Then You Die.
Check your glycol protection level. May not be rated down to the outside temperatures you are experiencing.
 

poda

New Member
Joined
Dec 13, 2008
Messages
17
Reaction score
1
Points
0
Location
centeral wisconsin
Vehicle Year
1992
Make / Model
ford
Engine Size
4.0
Transmission
Manual
Well I found the problem, the radiator is split along the plastic seams, causing it to overheat and the heat not to work. Thanks for all the info, and tips!
 

Sponsored Ad


Sponsored Ad

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top