- Joined
- Dec 5, 2008
- Messages
- 181
- Points
- 3,101
- Vehicle Year
- 1990
- Transmission
- Manual
i have a 1990 ranger 2wd 2.3 4 cylinder 5 speed. now the tranny i put in it leaks at the back of it where it is bolted together. the piece at the back of the tranny that bolts to the rest of the tranny. right between there it drips at the bottom for a few minutes until it cools down. it doesnt drip much just a 2 inch puddle. can i take some JB weld putty or epoxy and try to seal the bottom of it so it doesnt leak.
