CA, 1988 EFI 5.0l wiring

[flaymon1]

I have a 1988 EFI 5.0L engine I bough for my Thunderbolt project and its a CA, car and I'm noticing That The wiring diagrams I have from my repair manual on my downer car don't match whats actually on the engine, the harness for the injectors matches the book perfectly but the EECM harness is different none of the wiring colors jive at all.
GUESTION:Where can I get a CA 5.0l wiring harness diagram?

http://memimage.cardomain.net/member_images/1/web/2689000-2689999/2689357_47_full.jpg

http://memimage.cardomain.net/member_images/1/web/2689000-2689999/2689357_46_full.jpg

[SRL]

You can try helms for one. I think there's some other sites out there I can't remember off the top of my head.

If you're willing to spend a little more I might suggest you pick up Mustang electronics from '89 on. They're Mass Air which allows for engine mods and a lot of people know the stang stuff backwards and forwards so you'd get more help faster on forums like this.

In my 5.0 Ranger I took a Crown Vic engine and replaced the whole top end with stang stuff to get more hp than the lowly 160 the vic puts out.

The Crown Vic/Lincoln stuff doesn't see the widespread use the stang stuff does so we're a bit in the dark about it I'm afraid.