- Joined
- Nov 9, 2008
- Messages
- 14
- Points
- 3,101
- Vehicle Year
- 87,88
- Transmission
- Manual
Ok guys. I am new so dont be too hard on me, but i need to know something.
In the process of getting my block stripped down on my 2.3 (88 model)
an there is a metal canister type piece located just below the intake. has "s" shaped hose connected to it. How do i remove it?????
I tried gently prying it off but to no avail. I noticed there is a tin panel riveted to the block inside the crankcase.
Do i need to remove these rivets and maybe there is bolt holding this "canister" on??? Please advise...
Much appreciated!!
Justin
In the process of getting my block stripped down on my 2.3 (88 model)
an there is a metal canister type piece located just below the intake. has "s" shaped hose connected to it. How do i remove it?????
I tried gently prying it off but to no avail. I noticed there is a tin panel riveted to the block inside the crankcase.
Do i need to remove these rivets and maybe there is bolt holding this "canister" on??? Please advise...
Much appreciated!!
Justin
