slave cyd or master cyd?????


thumper

10+ Year Member

Joined
Dec 13, 2008
Messages
3
Points
3,001
Vehicle Year
1994
Transmission
Manual
when i got into my 94 4.o manual trans today and started it it jumped foward(it was in 1st gear with the clutch pedal depressed} i shut it off and check the fluid it was a little low but not entirely empty got back in to find that the pedal is going all the way to the floor with no resistance at even when pumped so is it the slave or the master is there a way to know for sure?
thanks in advance
 
locate the missing fluid. is it leaking out the master or slave?

theres a plug in the bellhousing that can be removed to inspect the slave.
 
hi
well the slave good the master was leaking but im still having trouble with th QD that thig is a pita,hase any one tried to bleed the system with a vacume pump?
 
i tried, it didnt help.

a lot of the times, the master cylinder cannot be properly bled with the cylinder bolted to the firewall. the way its positioned traps and air bubble inside the cylinder, behind the piston. you should unbolt the master cylinder and turn it upside down (line up) to bleed it.

im assuming QD is the quick disconnect. if the master cylinder is the problem, you dont need to mess with the quick disconnect. you can remove the line directly from the master cylinder by driving the tiny roll pin out of the master cylinder and pulling the line straight out.
 
You must log in or register to reply here.

Sponsored Ad

TRS Events & Gatherings

Where We Were in 2025 – The Ranger Station

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_4690.JPEG
IMG_4689.JPEG
IMG_4688.JPEG
IMG_4679.JPEG
IMG_4656.JPEG
IMG_4625.JPEG
IMG_4562.JPEG
IMG_4561.JPEG
IMG_4560.JPEG
IMG_4559.JPEG
IMG_4558.JPEG
IMG_4445.JPEG

Product Suggestions

Back
Top