Driver-Side Axle going in Crooked (35TTB)

robmurt90 · Dec 28, 2008

Had the driver side beam out to put 4.56 gears in and now that it's all bolted back up the axle shaft is crooked. It slides into the carrier but when you put the spindle on its sitting crooked, as in its resting on the inner lip of the spindle. It rotates fine but I can't get the lock ring in there, it won't tighten down enough.

Anyone have any ideas?

Destroyer000 · Dec 28, 2008

lock ring for the shaft? after the spindle is bolted on try pulling on the shaft a little or take a screwdriver behind it in the u joint an pull towards yourself.. this should allow it to have enough slack to put the clip on if thats what your talking about.

robmurt90 · Dec 28, 2008

trying that now actually, i'll let you know how it works. except I'm leaving it out a little bit then I'll just push it back in.

robmurt90 · Dec 28, 2008

worked. thanks.

Driver-Side Axle going in Crooked (35TTB)

robmurt90

15+ Year Member

Destroyer000

January 2009 STOTM Winner

robmurt90

15+ Year Member

robmurt90

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions