everybody gives advice,, i need some

mr.rangersir · Dec 24, 2008

bought 94 ranger 4.0 4x4 dana rear end. manual trans burnt up after 4 months of owning. had to replace . any way to stop from happening. only 112000, also need to replace ball joints, is this a job for the garage? i have access to most tools . any special advice? i loved this truck since i first drove it. :beer:

Wicked_Sludge · Dec 24, 2008

maintain the fluid level at the proper level with the proper fluid (ATF dex III or better).

the transmissions used in these trucks is a very robust and reliable unit...failure isnt common. there isnt much room for improvement.

Sunk · Dec 24, 2008

The rear isn't a Dana, it's a ford 8.8. The front is a Dana 35.

Ball joints are definitely something you can do yourself. Some may disagree, but all you should need other than normal hand tools, are a BFH, a c-clamp and a socket large enough to fit around the lower ball joint. And a hub socket of course.

mr.rangersir · Dec 24, 2008

thanks guys. good tips. i think im really gonna like this place.

everybody gives advice,, i need some

mr.rangersir

10+ Year Member

Wicked_Sludge

15+ Year Member

Sunk

15+ Year Member

mr.rangersir

10+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions