View Full Version : 4x4 not working
08-09-2007, 05:58 AM
Can anyone help me? Have 2001 Ranger. The lights on the dash blink 5 times and then go off for about three minutes. Then they blink 5 times again. These are the lights that indicate whether you are in 4wd hi, 4wd lo, or 2wd. The 4 wheel drive will not engage. Bought the truck used and do not have an owners manual.
Thank you in advance for any advice.
08-09-2007, 08:10 AM
Crawl under the truck and make sure the shift motor wires are attached. It is on the back of the Transfer case. If they are, then it could be a bad shift motor.
08-09-2007, 09:21 AM
Please don't double post, this topic is already in the transfer case forum.
02-25-2012, 08:39 AM
02-25-2012, 05:05 PM
It's trying to flash a code, but I can't find the flash code chart. You will need to find out what codes are in the memory.
02-27-2012, 02:46 PM
put it in whatever gear u had it in before ur problem say it was in 2wd and didnt engage make sure u have it there then disconnect your battery and reconnect it, it resets the computer or something and works...fixed mine atleast and i had the exact problem, good luck
02-27-2012, 03:32 PM
Bring out your dead.
vBulletin® v3.8.6, Copyright ©2000-2013, Jelsoft Enterprises Ltd.