- Joined
- Nov 14, 2008
- Messages
- 7
- Points
- 3,001
- Vehicle Year
- 1996
- Transmission
- Manual
Just picked up an 88 Merkur XR4Ti with LA3 already installed and a few other aftermarket parts. I am about to start the swap today. I only have a couple of questions.
1. Will I have to do any pinouts due to the fact I am useing the xr4ti's wire harness, computer, motor and trans. If so does anyone have an idea where I can find that information?
2. Will the Type 9 5 speed work just fine without the driveshaft being modified?
3. Also I have a 60 mm Mustang GT throttle body I was looking at putting on, is there anything special I have to do to it to make it work?
Any info would be great Thanks
1. Will I have to do any pinouts due to the fact I am useing the xr4ti's wire harness, computer, motor and trans. If so does anyone have an idea where I can find that information?
2. Will the Type 9 5 speed work just fine without the driveshaft being modified?
3. Also I have a 60 mm Mustang GT throttle body I was looking at putting on, is there anything special I have to do to it to make it work?
Any info would be great Thanks
