- Joined
- May 24, 2008
- Messages
- 976
- Points
- 3,101
- City
- Martinsburg W.V
- Vehicle Year
- 1988
- Transmission
- Manual
I'm going to be rebuilding my explorers 4.0 soon. It has a cracked head/gasket. My clutch,p/s pump and rad are shot (mud)
so ill be replacing those as well. I plan on removing the engine and using my parts explorers cylinder heads, pump and porting my upper and lower intakes and buying new clutch, slave cylinder, etc. I was wondering if I could fab some solid mounts for my 4.0. Every time I get into wheel hopping and heavy load issues my shifter stick is shaking back and forth terribly and I was wondering if this would help my truck to pull and run better offroad? Also any suggestions on my rebuild would be welcomed. thnx.
so ill be replacing those as well. I plan on removing the engine and using my parts explorers cylinder heads, pump and porting my upper and lower intakes and buying new clutch, slave cylinder, etc. I was wondering if I could fab some solid mounts for my 4.0. Every time I get into wheel hopping and heavy load issues my shifter stick is shaking back and forth terribly and I was wondering if this would help my truck to pull and run better offroad? Also any suggestions on my rebuild would be welcomed. thnx.
