Welcome Visitor! Please take a few seconds and 
cajunman87
New Member
- Joined
- Dec 2, 2008
- Messages
- 126
- Reaction score
- 0
- Points
- 0
- Location
- louisiana
- Vehicle Year
- 1998
- Make / Model
- ford
- Engine Size
- 3.0 V6
- Transmission
- Manual
i have heard a few things about changing the upper ball joints on a 98. some say to just throw away the entire upper control arm and get a new one with a new ball joint in place, and others say that the ball joints have to be pressed out with a hydrolic press. are they in there that tight that a normal ball joint press can't get them out? i have already changed my lowers but did not have enough time to get to my uppers. if anyone has any suggestions i would apreciate it.
