1986 ranger oil level sensor

XxDarkEuphoriaxX · Nov 24, 2008

Hi, I have the 2.3 liter 1986 ford ranger, automatic transmission, with a leaking oil level sensor. autozone and orielleys dont have one, and the dealer wants over 60 for one and its just a small part, im not paying that much..

is there any way i could just put a "x" sized bolt in the hole and seal it up with some sort of silicone or something? btw, there were no wires or anything connected to this sensor... it is one of the only places (i think) where oil is leaking from this truck..

thanks, Adam

exbass94 · Nov 24, 2008

Not sure if this is what you need, but Napa has an oil pressure gauge switch and an Oil pressure light switch for you truck for much less money.

mikepotts · Nov 24, 2008

the theads are "pipe thread", so... a simple pipe plug should suffice, just take your old sender to make sure you get the right size.

XxDarkEuphoriaxX · Nov 24, 2008

exbass94, those arent the parts I need x_x I eh, "customised" it with some yellow gasket silicone that is drying now, i was thinking about using it with more silicone to seal it up and hope it never leaks with no plans on ever taking it off again... dunno how well that is/would work x_x

pyro4fun · Nov 24, 2008

I had the same problem and still have not found a NEW replacement. I went to the junk yard and pulled about 3 of them when i was out there, so if it fails on me i have some spares.

1986 ranger oil level sensor

XxDarkEuphoriaxX

10+ Year Member

exbass94

15+ Year Member

mikepotts

15+ Year Member

XxDarkEuphoriaxX

10+ Year Member

pyro4fun

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions