Radar12158
New Member
- Joined
- Nov 13, 2008
- Messages
- 18
- Reaction score
- 0
- Points
- 0
- Location
- Perrysburg Ohio
- Vehicle Year
- 1997
- Make / Model
- Ford
- Engine Size
- 2.3
- Transmission
- Manual
I,m contemplating on replaceing the two piece driveshaft in my 97 Ranger,5spd manual 2wd. with a one piece shaft out of a 98+ model. I,m. trying to eliminate a driveshaft vibration. The truck at its stock riding height. Anybody else attempted this before? I read the tech article about the one piece swap for 4x4 on this website. It mentioned something about possible floor mods needed when doing this on a 2wd. Any info would be appreciated. Thanks!