Heat only work on High?

[94EXPLODER]

Hello,
I have a 94 Eddie Bauer and the heat/fan only turns on when i put the knob on high...i think its a switch near the firewall on the big aluminum foil looking thingy haha...any help would be nice...Thanks Alot!..
Oh yea the thermostat was done last spring...
Nick

[ghost_rader]

the part you want is the blower motor resister, it is to the right of the blower motor in the foil covered thing. it has 4 or 5 wires going into a plug in it. and there's 2 - 8 mil(5/16) screws holding it in.
replacing :icon_hornsup:that should let you have all heat levels again

[grey ghost]

here's a link that may help you see what to..
http://www.therangerstation.com/Magazine/spring07/blower_motor_diagnosis.htm
hope this helps:icon_cheers:

[94EXPLODER]

thanks...now that resistor is a dealer part right? no one would have that in stock..
about how much you think it would run me??
Thanks Alot Guys appreciate it!
nick

[grey ghost]

actually i bought one for my old '98 ranger at advance auto parts . i'd try a local parts store and call the dealer,parts store may have it cheaper

[3 of 7]

31 bux CDN at the dealer here ( I get family price, so I guess it'd be $50 tops)
I put one in mine from an older gen 1 Ranger... It didn't fit until I cut it up a little tho.
One thing I did do was cut the wire for the slowest speed... Hate having the fan run all the time when I don't need it.

[OldJunk]

Would no lower speeds on the blower motor on a '96 Explorer limited with the automatic temp. controls be the same problem?