Welcome Visitor! Please take a few seconds and 
- Joined
- Aug 11, 2007
- Messages
- 3,030
- Reaction score
- 21
- Points
- 0
- Age
- 36
- Location
- Edmonton Alberta
- Transmission
- Manual
So, I finished SASing my rig in june and finally got a chance to put a few miles on the rig. When I was assembling the steering, I noticed the TRE boots rubbed on my crossover steering setup. I figured I'd let it run until the first service (2500kms from current mileage) and deal with any issue that occured then...
I have found that the rubbing boots have caused them to split, due to the fact that the predrilled arms I bought from them have the TRE holes too close together. I have tried to contact them via phone call and email and have had no luck....Have any of you guys had this issue, or heard of it? I'd like to get something figured out before I lose a boot, and lose my mind...arg! Thanks
-andrew
I have found that the rubbing boots have caused them to split, due to the fact that the predrilled arms I bought from them have the TRE holes too close together. I have tried to contact them via phone call and email and have had no luck....Have any of you guys had this issue, or heard of it? I'd like to get something figured out before I lose a boot, and lose my mind...arg! Thanks
-andrew
