O2 sensor heaters...


skinner

15+ Year Member

Joined
Aug 27, 2007
Messages
324
Points
3,101
Age
41
City
Louisville, KY
Vehicle Year
1998
Transmission
Manual
I have a code for three O2 sensor heater conditions. I replaced 2 of them. Reset codes, and same three still throw codes. IS there an inline fuse or something i'm missing with these things? It's getting expensive and quite annoying tbh.
 
no fuse, but the heat is controlled by the PCM. maybe check all your PCM grounds to make sure they are solid.
 
thanks sludge!
Now, where can I find diagram of all the grounds on this truck? I'd love to get this thing out of the way!
Its weird...if I clear the codes...I can drive it clear to california without the CEL. When I shut it off...then restart it..bam...CEL with 5 codes(3 or 4 of them Oxygen sensor related). Rinse and repeat...
Seems to run well enough...
 
a haynes manual will list all the PCM grounds.

the o2 sensors are only heated until the exhaust system reaches sufficient temps that the o2's will function on their own...so this might explain why the cel only comes on after restarting it cold.
 
You must log in or register to reply here.

Sponsored Ad

TRS Events & Gatherings

Where We Were in 2025 – The Ranger Station

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_4690.JPEG
IMG_4689.JPEG
IMG_4688.JPEG
IMG_4679.JPEG
IMG_4656.JPEG
IMG_4625.JPEG
IMG_4562.JPEG
IMG_4561.JPEG
IMG_4560.JPEG
IMG_4559.JPEG
IMG_4558.JPEG
IMG_4445.JPEG

Product Suggestions

Back
Top