• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

i think my u-joint is done


lifted_Mazda01

New Member
Joined
Aug 31, 2008
Messages
119
Reaction score
0
Points
0
Age
35
Location
Davie, FLA
Vehicle Year
2001
Make / Model
Mazda
Engine Size
3.0
Transmission
Automatic
everytime i accelerate the driveshaft or something around the rear end sqeels like a pig, soon as i let off the gas it stops, or coming to a stop. i think its the u-joint, any other ideas??
 


Stumpy

New Member
Joined
Aug 7, 2007
Messages
267
Reaction score
0
Points
0
Age
34
Location
Tacoma area, Washington
Vehicle Year
1989
Make / Model
Ford
Transmission
Manual
Climb under and take a look, usually when a u-joint is bad it's fairly obvious. You might have to pull the driveline off to get a better look, there shouldn't be any play in the joint at all. They're really easy and cheap to rebuild too.
 

Wicked_Sludge

New Member
Joined
Aug 6, 2007
Messages
6,937
Reaction score
43
Points
0
Age
38
Location
Westport, WA
Vehicle Year
1993
Make / Model
Ford
Engine Size
3-point-GO
Transmission
Manual
u-joints usually produce an intermittent "squeak, squeak, squeak" as the driveline goes 'round. id still check it, but my bet is the u-joint isnt the problem.
 

bobbywalter

TRS Technical Staff
TRS Event Staff
V8 Engine Swap
TRS Technical Advisor
TRS Banner 2012-2015
TRS 20th Anniversary
Ugly Truck of Month
TRS Event Participant
Joined
Aug 9, 2007
Messages
23,470
Reaction score
4,668
Points
113
Location
woodhaven mi
Vehicle Year
1988
Make / Model
FORD mostly
Engine Type
V8
Engine Size
BIGGER
Transmission
Automatic
2WD / 4WD
4WD
Total Lift
sawzall?
Tire Size
33-44
My credo
it is easier to fix and understand than "her"
two piece driveline?

sure it isnt a belt? or a loose skidplate rubbing the shaft?
 

LITTLE FOOT

New Member
Joined
Aug 28, 2008
Messages
573
Reaction score
3
Points
0
Location
BUFFALO, NY
Vehicle Year
1993
Make / Model
FORD
Engine Size
5.7
Transmission
Manual
mine did that. it was the u-joint
 

thegoat4

New Member
Joined
Aug 12, 2007
Messages
613
Reaction score
6
Points
0
Vehicle Year
1998
Make / Model
Ford
Transmission
Manual
Take it on a short drive, the park and feel your u-joints. If you have a bad one it'll be burning hot, or just hotter than the rest, depending on how you drove it.
 

Bryan22

New Member
Joined
May 2, 2008
Messages
1,610
Reaction score
4
Points
0
Age
39
Location
So-Cal babay
Vehicle Year
94 extd
Make / Model
Ford
Engine Size
94 2.3
Transmission
Manual
Get under the truck grab the drive shaft and rotate it back and forth. look for play in the joints. also check the bolts that attach the driveline to the diff. they came loose on my 92 once and made the truck act really funny. That being loose along with a bad U-joint made a hell of a racket too.
 

lifted_Mazda01

New Member
Joined
Aug 31, 2008
Messages
119
Reaction score
0
Points
0
Age
35
Location
Davie, FLA
Vehicle Year
2001
Make / Model
Mazda
Engine Size
3.0
Transmission
Automatic
ok will check tomorrow b4 work thanks guys, if not u-joint what else, cause its obnoxious and i dont want to end up stranded
 

PaleBlue90

New Member
Solid Axle Swap
RBV's on Boost
Joined
Aug 6, 2007
Messages
3,650
Reaction score
5
Points
0
Location
Aurora Colorado
Vehicle Year
88,89,90,92,93
Make / Model
FORD
Engine Size
2.3,2.9 and 4.0
Transmission
Manual
my u-joint did that, i went to get the part during school and and on my way home it failed breaking the ears off on my driveshaft :(
 

bobbywalter

TRS Technical Staff
TRS Event Staff
V8 Engine Swap
TRS Technical Advisor
TRS Banner 2012-2015
TRS 20th Anniversary
Ugly Truck of Month
TRS Event Participant
Joined
Aug 9, 2007
Messages
23,470
Reaction score
4,668
Points
113
Location
woodhaven mi
Vehicle Year
1988
Make / Model
FORD mostly
Engine Type
V8
Engine Size
BIGGER
Transmission
Automatic
2WD / 4WD
4WD
Total Lift
sawzall?
Tire Size
33-44
My credo
it is easier to fix and understand than "her"
a bad joint vibes.

didnt see where you had a vibe issue.

so i was under the assumption you looked and didnt see an obvious joint fault and was wondering if it was starting to dry up and was gettin ready to fail..and this was a condition leading to it.

the hanger bearing on the other hand will squeal as its last days approach without big vibe issues initially. with worn or failed tranny mount/engine mounts it can load the bearing to where it will squeal or shift the drive shaft to rub something.


i could never know without phsically inspecting the vehicle. could just be the brakes...broke spring or simply worn...or the rear wheel bearing is going...leading to a shift condition in the situations listed...


:fie:hell i could go on and on...
 

lifted_Mazda01

New Member
Joined
Aug 31, 2008
Messages
119
Reaction score
0
Points
0
Age
35
Location
Davie, FLA
Vehicle Year
2001
Make / Model
Mazda
Engine Size
3.0
Transmission
Automatic
yea me 2 i just hope, pray, etc its my u-joint, cheap fix, but ball joints and shocks are next
 

lifted_Mazda01

New Member
Joined
Aug 31, 2008
Messages
119
Reaction score
0
Points
0
Age
35
Location
Davie, FLA
Vehicle Year
2001
Make / Model
Mazda
Engine Size
3.0
Transmission
Automatic
yea it was the u-joints, after changing them seems to have been slipping the driveshaft, but got all my balls back tonight
 

Sponsored Ad


Sponsored Ad

Staff online

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top