- Joined
- Aug 17, 2008
- Messages
- 1
- Points
- 3,001
- Vehicle Year
- 1997
- Transmission
- Automatic
I recently purchased a set of Ranger rims and tires that came off of a 2008 Ranger 4 wheel drive. My intent was to put them on my son's 97 XL 4 wheel drive. The rear rims fit just fine but the front center knock out holes are to small to allow the 4x4 hub (automatic) to pass through.
Is there any way I can get these to fit?
Is there a smaller hub available?
Can I grind them out with out compromising the strength of the alum wheel?
Any and all help would be much appreciated as I would really like to use these rims and tires.
Thanks!
Is there any way I can get these to fit?
Is there a smaller hub available?
Can I grind them out with out compromising the strength of the alum wheel?
Any and all help would be much appreciated as I would really like to use these rims and tires.
Thanks!
