LordVngr
New Member
- Joined
- Jul 5, 2008
- Messages
- 46
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1989
- Make / Model
- Ranger
- Engine Size
- 2.9L
- Transmission
- Manual
Ok, Soooo How do I take this off
With This
I just Dont Get It.
I Also found out that I have Dealer Installed AC. Check out my hose connections. The condenser hose's use the same type clamp. Is that going to hold up to the pressure of R-134a.
I was pissed when I found out I had Dealer installed AC. I'm trying to rebuild my AC system. Couldnt I just use the compressor bracket from a junkyard and install the factory compressor / condensor / hoses instead of this style and it's mickey mouse setup. Also since it is dealer installed I guess that means I have a expansion valve too. where might that be located on a 89 Ranger.
Thanks..............................
Thanks
With This
I just Dont Get It.
I Also found out that I have Dealer Installed AC. Check out my hose connections. The condenser hose's use the same type clamp. Is that going to hold up to the pressure of R-134a.
I was pissed when I found out I had Dealer installed AC. I'm trying to rebuild my AC system. Couldnt I just use the compressor bracket from a junkyard and install the factory compressor / condensor / hoses instead of this style and it's mickey mouse setup. Also since it is dealer installed I guess that means I have a expansion valve too. where might that be located on a 89 Ranger.
Thanks..............................
Thanks
Last edited: