shifter

patrick leadabrand · Jun 20, 2008

i took the shifter out on a 93 ranger i just got for my daughter . there was a lot of play and almost impossible to find third. the passager side pin that fits in the grove on the shifter ball was worn real bad. i spun it 90dgrees and put it back in. it seems much tighter but the problem is it just feels like it is in neutral and it wont go into any gears its stuck in first. should i have put in neutral before taking the shifter out? if so how do i get it in neutral now. i tried a big screw drive but it would work.. Plz help PS its a 2wheel drive

AllanD · Jun 22, 2008

Ok first off this is a transmission topic so I'm going to move it.

Second it's EASIER to reassemble the shifter on the M5OD-R1 trans with it in neutral
but not strictly necissary.

If the shifter is still "sloppy" what you need from your local ford dealer's parts counter to fix it is TWO Ford P/N 1L2Z-7228-AA, they should cost about $10each.

Ford calls them a "spring" but they are really a blue urethane bushing that the shifter ball pivots in.

If the lower one is missing (not unusual) the shifter will be sloppy as hell.

I can also tell you CHANGE the tranny oil immediatly and hope you get most of the plastic chunks.

Ranger44 · Jun 22, 2008

http://www.therangerstation.com/forums/showthread.php?p=37704#post37704

This might help a little with the stuck shifter. An old post.

http://www.therangerstation.com/Magazine/winter2007/shifterbushings.htm

Sloppy shifter

and yes, replace the tranny fluid (Mercon ATF). The bushings seem to disintagrate over time, and end up in the fluid.....possibly harming things.

shifter

patrick leadabrand

10+ Year Member

AllanD

TRS Technical Staff

Ranger44

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions