Messed Up Bumper
- Thread starter scappy
- Start date
kunar
Forum Staff Member
TRS Forum Moderator
⭐Supporting Member
Article Contributor
TRS Event Participant
V8 Engine Swap
- Joined
- Jun 10, 2003
- Messages
- 4,177
- Points
- 5,101
- City
- Toledo
- State - Country
- OH - USA
- Vehicle Year
- 1987
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Engine
- 351
- Transmission
- Manual
kinda depends on what you mean by 'messed up'
i would fab something up outta 2x6 square tube with a built in receiver, winch mount, d-rings and a couple of flood lights for good measure
- Joined
- Jan 2, 2001
- Messages
- 8,001
- Points
- 5,101
- Age
- 42
- City
- Lancaster, Ohio
- Vehicle Year
- 2016
- Engine
- Transmission
- Automatic
- Total Lift
- 5"
- Tire Size
- 35"
You could always do what they do on American Chopper and chain it to another truck and floor it....
Takes care of the bumper.
Takes care of the bumper.
- Joined
- May 5, 2008
- Messages
- 744
- Points
- 3,101
- Age
- 49
- City
- Kelowna, BC
- Vehicle Year
- 2010
- Transmission
- Automatic
I rubbed a chainlink fence with my 07 when my master cylinder failed. Damage wasn't much more than chainlink scratches that I had buffed out at alocal body shop.
Local Ford dealer paid for it as well since it was kinda Ford's fault.
You should post some pictures to get better advice...
Local Ford dealer paid for it as well since it was kinda Ford's fault.
You should post some pictures to get better advice...
- Joined
- Aug 7, 2007
- Messages
- 2,243
- Points
- 3,101
- Age
- 54
- City
- Farmington Il.
- Vehicle Year
- 1988
- Transmission
- Automatic
Back into the same fence with the other side and make them match.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
