how to remove frozen front yoke u-joint caps


smittylopez

15+ Year Member

Joined
Apr 30, 2008
Messages
17
Points
3,101
Transmission
Manual
The caps on my truck and replacement are rusted solid. Ive soaked them in PB blaster but I am still bending my torx #30 bits. I can't get a solid bite with a wrench or socket either. What do you guys do?
 
Last edited:
try to get some heat on em
 
That what I was thinking but my torch outfit is at work for the weekend.
 
Even a propane torch will work wonders getting those bolts out, works everytime I come across frozen u-joint bolts.
 
no heat!!!!!! hit the side of the yoke with a brass hammer! comes out like butter! hit right about the base of the "u" right under the cap its self.
 
Actually, a LITTLE heat (no more than propane) will melt the threadlocker that comes on those bolts from the factory. But you do risk melting the pinion seal, which is a HUGE PITA to replace.

If you're using cheap T-30s, get a good one. For this very reason (BTDT).
 
is he talking about the actual round caps on the u-joint, or the straps that hold em on? wtf?

whoops, finaly saw the torx part! sorry, about that
 
is he talking about the actual round caps on the u-joint, or the straps that hold em on? wtf?

whoops, finaly saw the torx part! sorry, about that


Yup, he's talking about the bolts that hold the straps on over the u-joint. Confused me at first as well.

Put some heat on the end of the yoke. You can go with a decent amount, as it takes a lot to heat the whole thing up enough to toast the seal. Just use your best judgement. And get some high quality bits.
 

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram


Product Suggestions

Back
Top