I am getting my lights on Tuesday so I will probably wire them up then....How do I get the wires inside the cab without drilling a hole in the cab?
Light bar.....how do i get the wires inside the truck?
- Thread starter mjonesjr
- Start date
- Joined
- Aug 28, 2007
- Messages
- 2,274
- Points
- 3,101
- City
- Durham, NC
- Vehicle Year
- 1999
- Transmission
- Automatic
There are a few places in the floor of the cab where there are holes, with rubber plugs in them. You can put a hole in the rubber, and run the wire into the cab.
- Joined
- Nov 28, 2007
- Messages
- 7,898
- Points
- 3,101
- Vehicle Year
- 1988
- Transmission
- Automatic
Well I don't know about a roof mount. I would drill a hole somewhere where it cant be seen. But really, id wait until you get a better opinion than mine 
- Joined
- Aug 8, 2007
- Messages
- 247
- Points
- 3,101
- Age
- 51
- City
- High Desert, Calif
- Vehicle Year
- 1987
- Transmission
- Manual
Light bar on a ranger or B2? A buddy of mine has a light bar on his B2 and runs the wires into the door jamb.
- Joined
- Feb 25, 2008
- Messages
- 694
- Points
- 3,101
- Vehicle Year
- 1997 , 1992
- Transmission
- Manual
ya if you look at my truck it has a light bar on top and my dad wired it up for me and he hide the wires underneath the light bar then down the side in into the weather molding in the door jam then down towards the front of the door then underneath the weather molding then into the cab and behind the dash to hide them.
Sponsored Ad
TRS Events & Gatherings
Latest posts
-
-
-
-
-
-
-
Specific Radio Boss (note not Bose, but Boss) 632UAB
- Latest: Li'l Work Truck
-
-
-
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
