clutch master cylinder


davidbmd

10+ Year Member

Joined
Aug 20, 2012
Messages
16
Points
1,601
Vehicle Year
1986, 1985
Transmission
Automatic
Can I rebuild the clutch master cylinder

Can the line be removed to save it

Is a seal kit available as my bore is clean as a wistle

can a complete master cylinder be bought with the line attached?

Thanks
 
the line can be removed with breaking it. If its original good luck. More than likely it wont come out and will have to be broke. And you can buy a master with line attached and pre bleed.
 
Last edited:
I just changed the clutch and slave and master and didnt break anything..... its all how you do but from what I have been told.. buying the slave and master hooked to the line already bled is better.. ya you will spend extra dollars but its worth it in the long run.... trust me. I went the buying everything seperate and it took 4 hours of bleeding the line to get the clutch to work properly.. If I had the vacuum pump it would have been easier..
 
If it took you 4hours to bleed the system then you did it wrong. It should take maybe 30 mins if your bench bleeding, which is recommended to make it easier.
 
You must log in or register to reply here.

Sponsored Ad

TRS Events & Gatherings

Where We Were in 2025 – The Ranger Station

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_4690.JPEG
IMG_4689.JPEG
IMG_4688.JPEG
IMG_4679.JPEG
IMG_4656.JPEG
IMG_4625.JPEG
IMG_4562.JPEG
IMG_4561.JPEG
IMG_4560.JPEG
IMG_4559.JPEG
IMG_4558.JPEG
IMG_4445.JPEG

Product Suggestions

Back
Top